EMPI3229 dual port installation kit with red stepped urethane boots, clips, and manifold gaskets.
Dimensions:
Please note that there is no sizing difference between the black and red version of this product: purely cosmetic differences.
EMPI3228 dual port intake kit with black stepped urethane boots, clips, and manifold gaskets.
Dimensions:
Weber replacement carburettor to suit the Landrover Series 2a and 3 2286cc engine Right Hand Drive models originally fitted with a Zenith 36IV.
Kit includes:
Standard jetting :
Idle jet used on Zenith 40 TIN carburettors.
Please click on the drop down to specify the size you would like to purchase.
Dimensions:
Emulsion tube used on Weber carburettors type:
Please click on the drop down to specify the size you would like to purchase.
Beware of poorly made cheap copies!
Genuine Dell’orto jet cover screw for DHLA and DHLB carburettors.
Genuine Dell’orto T1.12DA carburettor, New old stock.
Clamp type fitting – 15.8mm
Showing signs of slight surface corrosion on exterior of body screws due to age and storage.
Fitted cable should be considered un-servicable due to stiffness in operation.
Supplied with air filter assembly as shown.
Retaining clip and fixings to retain Dell’orto SHA air filter boxes.
Approx 64mm internal diameter.
Made by Lynx in Australia.
Hi-volume, flame resistant and washable.
600 cubic feet per minute rating.
Only 52mm deep, good for installations where space is limited.
Approximately 232 mm long x 140 wide.
Ramflo filter for Weber DCOE 38, 40 or 42mm carburettors which use slot in trumpets, this filter will replace the trumpet and still give good airflow in to the carburettor.
Made by Lynx in Australia.
Hi-volume, flame resistant and washable.
400 cubic feet per minute rating.
Only 52mm deep, good for installations where space is limited.
Approximately 180mm wide x 115mm tall.
Includes:-
Not Suitable for use with trumpets
