Italian made service kit to suit a pair of Dell’Orto DHLA 40 carburettors.
Kit contains:
- Top cover gaskets
- Pump diaphragms
- Pump cover gaskets
- Inspection cover gaskets
- Air filter gaskets
- Base gaskets
- Throttle return springs
- Pump diaphragm springs
- 150 Float needle valves
- O rings and seals
Italian made service kit to suit a single Dell’Orto DHLA 40 carburettor.
Kit contains:
- Top cover gasket
- Pump diaphragm
- Pump cover gasket
- Inspection cover gasket
- Air filter gasket
- Base gaskets
- Throttle return spring
- Pump diaphragm spring
- 150 Float needle valve
- O rings and seals
A Weber performance kit to allow fitment of 3 x Genuine Spanish Weber 45 DCOE carburettors to Datsun/Nissan 240Z, 260Z and 280Z engines.
The carburettors come with a standard jetting found here: 19600.060
Kit contains:
- 3 x Weber 45 DCOE carburettors
- x Webcon intake manifolds
- 1 x Webcon linkage set
- Soft mounts, studs, nuts, washers etc.
- Tuning guide
Special order item, please allow an extra 2-3 days for delivery
Pair of chrome air filters to suit Solex 40 PII carburettors.
As used on:
- Fiat 124 Sport
- Porsche 912
- Carrera 356A & 356B
- Super 90 616A
Dimensions:
- 225mm long
- 135mm wide
- 83mm deep
Datsun 240/260/280 Z manifold to suit triple DHLA / DCOE supplied with full linkage kit
Drilled and tapped to accept brake servo union.
Supplied with:
- Manifold studs
- Flexible mounts
- T unions
- Vacuum take-off
Weber DCOE / DCOM jet cover assembly in the new silver design.
Includes:
- Wingnut
- Small fibre washer for the wingnut
- Large fibre washer for between the cover and carb top
An alternative design jet cover is listed here
Weber DCOE / DCOM jet cover assembly in the original gold colour.
Includes:
- Wingnut
- Small fibre washer for the wingnut
- Large fibre washer for between the cover and carb top
An alternative design jet cover is listed here
A Webcon replacement carburettor to suit Bedford CF 2.3L vans between 1975 & 1979.
Please note: The carburettor used in this replacement carburettor kit is a Weber 34ICH type which replaces the Weber 34 ict type fitted as original equipment and CANNOT be used to replace A Zenith 36IV carburettor.
This kit is supplied with the throttle cam and spring.
Kit includes:
- Weber 34ICH carburettor jetted to suit.
- Fitting kit
- Fuel line, fuel filter and clips
Standard jetting:
- 29mm choke (fixed)
- 4.5 Auxillary venturi
- 147 Main jet
- 50 Idle jet
- 145 Air corrector
- 50 Pump jet
- F78 Emulsion tube
Twin 45 DCOE carburettor kit to suit Triumph Dolomite Sprint engines.
Kit contains:
- 2 x Genuine Weber DCOE45 carburettors
- Cast aluminium inlet manifold.
- Linkage and soft mounting parts.
Carburettors come with a starting point jetting spec as seen here.
Reconditioned genuine Lotus Manifold, fits 2.0 and 2.2 litre engines.
Ultrasonically cleaned.
Engine ports are approx 24mm x 47mm